Asked Questions (FAQ)
Customers and Subscribers are saying...
Dave's Dictionary of Appliance Terms
My Personal Blog
Garage Door Nation
(Springs, Parts, DIY)
Has my website been
Free pdf Readers:
Did you Know?
You no longer need a Paypal account to make payments using
your credit card!
A Gift for You
Dave's Repair Service
1911 Heath Hill Rd
New Albany, PA 18833
Sunbeam Mixmaster Governor Capacitor
(Used in Vintage Models 5 thru 12)
Here's a rare governor capacitor for
the great old Sunbeam Mixmaster stand
mixers, models 5, 7, 9, 10, 11, 12.
longer available from Sunbeam, this is
a brand new - NOT USED - capacitor. I
fabricate these myself, from high quality new
parts, and guarantee them to work great
in the above vintage mixer models.
Approx. 1-3/4" long, 1/2" diameter, the
original part this capacitor replaces
was rated .08uf at 160 volts AC, Sunbeam part #10-2065 (this one's my
part #10-2065X), also old numbers C31AD,
C47CN. Mine's rated at 600 volts AC, so it
also works in 220 volt models.
Note: when the original capacitor shorts
in one of these mixers, as commonly
happens, it will run on high speed only,
no matter where you set the dial. To
verify a bad capacitor, pry it out
temporarily (it's the bottom cylindrical
component - the upper one's a resistor) and run the mixer briefly
without it. If its speed varies normally, you immediately know the
capacitor's the problem (don't run one
too long without this part installed,
though; it'll burn the
help with a "high speed only" vintage
(model 5 thru 12) Mixmaster, see
you should have any questions or need
any other Mixmaster parts, please feel
free to ask me. I stock some 200 vintage
Mixmaster motors for parts.
pickup service, parts, and owner's manuals for your
direct, high quality scans of the
original, no longer available factory service manuals my Dad and I used
These capacitors sell to US buyers* for $13.50 plus
$8.50 Priority shipping, $22.00 total for one. I can Priority ship up to
20 of them to your US address* for the same shipping cost. If you'd like to order
more than 10 at once, please contact me first. I make these in my own shop and always keep
a quantity on hand. But I'm a "one man show", so large quantities can
take me a few days to fabricate. I've just started offering a
modest quantity discount on 10 or more
of these, so please
ask about that before ordering.
(You don't need a Paypal account
to securely pay using your credit card!)
USPS International Shipping Rates have gone sky-high!
Please email me for rates, especially if you're in Australia or Canada.
*If you live outside the U.S. or just have a question about these
here to email me.